Tycon Wireless - eZbridge EZBR-0214HD+ 2.4GHz Industrial PtP Bridge System

 Tycon Wireless - eZbridge EZBR-0214HD+ 2.4GHz Industrial PtP Bridge System
Tycon Wireless - eZbridge EZBR-0214HD+ 2.4GHz Industrial PtP Bridge System
The EZ-BridgeLT-HDâ„¢ is a high power 250mW outdoor wireless bridge system with built in Ethernet and AC Power surge protection for ultra reliable operation in harsh environments. The complete system comes with two 75' Shielded outdoor rated Cat5 cable assemblies to protect against EMI caused by lightning

The system operates in the 2.4GHz or 5GHz unlicensed frequency spectrum providing real world thruput up to 20 Mb/sec. It complies with the 802.11bg or 802.11a standards to insure interoperability. The EZBridgeLT-HDâ„¢ creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight. It supports multiple MAC addresses and DHCP across the wireless link. It is the perfect plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access. Multiple EZ-BridgeLT-HDâ„¢ units can be connected in a mesh configuration to allow interconnecting more than two sites.

With its password verification, MAC address authentication, SSID suppression and advanced WPA encryption, the system provides the best available wireless data security.

Installation is a snap because of the plug and play features which have been built into the system. Just install the antennas and plug in the power supplies. The units will automatically find their peer and create a secure wireless network link. If changes to the pre-configured settings are desired, they can be easily done thru the built-in web interface from any point on either side of the network. There are no drivers or software that needs to be loaded to the computer.

The EZ-BridgeLT-HDâ„¢ comes complete with all the electronics that are needed for a point to point wireless network bridge installation; including 2 powerful 14dBi 802.11bg or 19dBi 802.11a antennas with built-in high power electronics, Bracket Kits which accommodate pole or wall mounting, Surge Protected 18V POE (Power Over Ethernet) power inserters and 75' Shielded Outdoor Rated CAT5 cable assemblies.

Price: $299.95
Product Details
High Power Electronics and powerful antenna Operation up to 3 miles with good line of sight and up to 100 Mbps real world throughput
True Plug and Play No driver needed. Pre-configured at the factory for automatic peer to peer communications
64 and 128bit WEP, WPA and WPA2 Encryption Most powerful data security available
Web-based configuration Remotely change device configuration or update firmware from anywhere on the network
Power over Ethernet Antennas can be mounted up to 100meter (300’) from the power inserter
Product Reviews
Rate this product:  1   2   3   4   5